1. Tirfor T516 D 1.6 Tonnes / Tirfor T532 D 3,2 Tonnes

The Tirfor ® devices are portable manual hoists cable passing. They can lift, pull and position loads over a long distance while keeping maximum torque. They can be used in various configurations and with long lengths of cable. The maneuvers are made using a lever. Optional use of a sheave pulley system allows to increase the capacity of the apparatus.
Hand winch cable from
tirfor
- Reduced Weight
- Rapid implementation
- No limitation of cable length
- Handy, lightweight, rugged, powerful
- Multiplication capacity with deflection sheaves
- Protection against overload
- Millimeter positioning of the load

2. Tralift (Palan manuel) 2T

Tralift™ type hoists are manual chain hoists. They are used to lift loads. The product is very easy to install. For lifting, the hoists are usually attached to Corso clamps or trolleys. Lifting or positioning of a load using a Tralift™ lever hoist.
- Models from 250kg to 20t
- Robust design
- Swivel hook with safety catch
- Hook with overload deformation indicator
- Automatic brake with double pawls
- Heavy duty bearings
- The chain length can be adjusted in the neutral position, i.e. without load.
- Option: load limiter

3. Tralift TE (Palan électrique)

Tralift™ TS hoists are motorised chain hoists. They are used to lift loads. The device is designed for permanent installation on a jib crane, underneath an overhead crane, or on motorised or non-motorised trolleys. The device is directed by a control box.
It exists in a single or three phase version with high duty factor adapted to hard working conditions. A range of products is also available on demand for specific needs in the food sector (stainless steel) or VLLH (Very Limited Loss of Height) and we are able to provide special versions adapted to your needs for minimum order quantities (depending on the version requested).
Options:
- Radio remote control
- Tropicalisation
- 60 HZ version
- IP 65
- Special paint
- Direct command
ELECTRIC CHAIN HOIST IN VERSION 1 Bm, 1Am and 2m according to FEM. Other duty cycles available upon request.
Capacity: from 60 kg to 5000kg.
- Adjustable top and bottom limit switches
- Safety low-voltage control
- Emergency stop
- Friction-type load limiter
- Power supply voltage 230 or 400 V, Three-phase, 50 or 60 Hz. Other tension available upon request (ex: 380V-60HZ)

4. Dynafor LLX2 5T

DYNAFOR™ LLX2 devices are precision load indicators to measure tensile forces (N) and to determine hanging loads (kg).
One DYNAFOR™ LLX2 units consists of a sensor and a remotely installed display (2,4 Ghz connection).
PC connection via USB port. Optional Monitoring software
Accuracy : 0,1 %
Available models from 500 kg to 10 t.